Exhaust
Controlling Fume Extractors With Your Thunder Laser
Always reference the OEM manufacturers instructions, diagrams, pinouts, etc... and verify all connections. This article shows typical installations but it could vary. Filtrabox On the Filtrabox Compact X (and likely other Filtrabox units) you short ...
HF-75S 3 Inch 27 CFM MIXED FLOW INLINE FAN
Filtrabox Fume Extractors
You can find specs on all the units listed here on the Filtrabox Website: https://filtrabox.com/product-category/laser-fume-extractors
Adding Manual Exhaust Fan Control
LightBurn now has start timers built in so the fan can spool up before the job starts. There are settings for end delay time too, but leave that at 0 because end delay is controlled by the TL-Timer. More information can be found on that here. There ...
HF-150PE 6 Inch 381.81 CFM ECO-Watt Mixed-Flow Inline Fan
NOVA 24, NOVA 35 ODIN22, and Odin 32 (from container #103 forward) are now are equipped with HF-150PE. 1. 6 inch 150mm 2. EC motor, high air volume, low power. 3. IP44 protection level 4. 647m³/h (381.81 CFM) airflow, 503 Pa (0.072954 psi) air ...
Using Aftermarket Inline Exhaust Fans
Why use an aftermarket fan The usual reason is to mitigate noise levels on the CZ-TD550 centrifugal fan. The W150 stock fan is an axial inline fan and is already pretty quiet. NOTE: ALL THUNDER MACHINES Q3 2021 CONTAINER #103 AND NEWER HAVE OEM ...
W150 Inline Exhaust Fan Specs
The Vtronic W150-01 inline axial blower fan is a 2 speed fan with the following specs (323 CFM high speed and 259 CFM low speed): NOTE: Some newer models may not be dual speed You may see people upgrading to another inline fan but few change out this ...
Venting The Exhaust From Your Thunder Laser
Preface: This article covers some key points about Venting Your Laser and adapting aftermarket exhaust components Important Considerations: Existing Systems Do not connect the exhaust output of this laser to an existing exhaust system. Please consult ...
Cleaning Your Stock Exhaust Fan
Preface: This article covers cleaning your exhaust fan and the air flow path. The exhaust fan shall be disconnected from the machine electrically before servicing Before you begin: -Gather tools to service the fan and exhaust. You will need ...