Calibration and Replacement
Aurora Series Belts
Preface: This article covers Aurora Series Belts for the door. How to read a Belt Part Number: (Note that Length may be omitted when buying bulk or when searching for bulk length belt) Aurora Manual Door Aurora Auto door Aurora Manual Door Location ...
Aurora Camera Setup and Usage
Preface: Use this guide to set up your Aurora Camera and for the basics of how to use the camera Please note that we do not currently have documentation for the calibration procedure in Lightburn V2.1.xx. You will need to follow the standard ...
How to calibrate and use the manual focus on the Thunder Laser Aurora Lite Laser
Preface: This article covers how to calibrate the manual focus T-Bar and how to use the red dot focusing tool for your Aurora Lite Laser Quick start Video:
EzCad Red light Pointer Marking Tips for lining up a Jig for Aurora Fiber
This article covers some tips for using the Red Light Pointer for your Aurora Fiber Laser while using EzCad Things to check before using the Red Light Pointer: Alignment Before you start: Have your jig installed and secured to the bed in a repeatable ...
Aurora Top Panel Removal
Be sure to remove main power and de-energize the equipment before performing any maintenance operations take pictures beforehand for your refence then reassembling. Remove the 6 hex screws Remove and retain the 6 hex screws that secure the top panel: ...
Aurora Beeps Continuously
Autofocus out of range
Aurora Series Over Temperature Error
Here are the steps to mitigate an over temp message in ezcad Check The E-Stop Pulling out on an estop can damage its mechanism. The machine can appear to look fully powered-up and ready even with the e-stop engaged. Gently twist the button to the ...