Aurora Beeps Continuously

Aurora Beeps Continuously

Autofocus out of range




    • Related Articles

    • Aurora Series Unified User's Manual

      Please see the manuals for both Aurora series V1 and Aurora series V2 attached below Note that the manual is Windows and Ezcad centric due to being the GLOBAL manual. Thunder Laser USA has compiled information on Lightburn, Windows and MacOS in this ...

    • The Machine Beeps Continuously

      Problem description: You can hear a beep continuously that comes from the indicates light, even if the machine is rebooted. It will sound like this: If the sensor tripped from a legitimate heat event, then it will need time to cool down to clear the ...

    • Aurora Series Wiring Diagram v8.4

      Please see attached. These are for the V1 Auroras that do not have a Keyed switch on the front.

    • Aurora Auto Door

      Preface: This article covers how to perform an electronic bypass of the AUTO Door and how to adjust the AUTO Door if it is malfunctioning. Aurora AUTO Door Bypass Bypassing the Aurora AUTO Door is quite simple and you can even add a handle to fully ...

    • How to identify the Focal Lens on your Aurora Laser

      Preface: This article covers how to determine which lens you have installed on your Aurora Fiber Laser Visual Marking: Look for the F-### on the lens. It should be either F-160,F170, F-210, F-220, F-254 or F-290. For additional information, please ...
    If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.

      Information contained in this Knowledgebase, on this page, in this or any other  Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.