Replacing The Head Assembly
Related Articles
Thunder Laser USA Beam Buddy HR Head Information & Instructions
Description Our Thunder Laser USA Beam Buddy High Resolution Head is manufactured in Canada to our specifications and this head performs a bit better than the stock Thunder HR Head. More on that here: ...
Four Inch 4" Laser Head Assembly and breakdown of Lens, Extension and Cone install
Preface: This article shows the assembly diagram for the Thunder Laser 4" head. Assemble the Lens in the order shown:
Odin Series Lens Assembly Check
Previous Design: A is the fixing nut for the lens assembly. B is the lens assembly: Here is how you can check that the lens is properly positioned and secure: New Design: We have new design of lens assembly, the video is coming: To inspect the lens, ...
How To Replace The Nova Series DC Tubes
Firstly, turn off the whole machine power. VIDEO HOW TO: INSTRUCTIONS (may vary but the principle is the same): Tools\Supplies Needed: 3mm Allen Key (For Tube Straps, Extension Access Panel and HV plug retainer set screw) Flat Head Screw Driver for ...
Gaining Extra Clearance With The 4" Head
The distance from the lens to the work is the focal point and that distance never changes. The extension tube and the nozzle are just to get the air assist close to the work and maintain the prescribed 10mm gap from the nozzle to the material for ...