This article is a How To: for customers whose air pressure sensor signal was interfering with the controller, causing the Touch Panel to display garbled pop-ups during operation. Changing the following values can effectively avoid this signal ...
Preface: This article covers the wiring for a 5 pin rotary based on the V5 TL Timer Wiring Schematic Wiring at Port: Port: Ruida Controller Connections: This design uses common signals with the Y Axis D2 connector Pin Designations: Pin 1 - +36V - ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.