Nova Series DSP TL Timer Mid 2020 Block Diagram v8.3

Please see attached.

TL TIMER v8.3

FLAP v4.1

NOTE: 

This circuit diagram has 6 pages. The first page and last page for all machine are the same.
The second page is no OPTO-isolator of nova24, third page is for Nova 24 with OPTO-isolator. 

The fourth page is Nova 35, and the fifth page is 51 and 63.

All Thunder Laser USA equipment is 110v AC only, regardless of the tech documents contained here.

• Related Articles

• Nova Series DSP TL Timer V8 2019 Block Diagram

  NOTE: The current version (v8.4) can be found here: Nova Series DSP TL Timer Mid 2022 Block Diagram v8.4 This is the Nova Series DSP TL Timer V8 Block Diagram. The full resolution PDF of this diagram is attached below.

• Nova Series DSP TL Timer V6 Block Diagram

  Nova Series DSP TL Timer V6 Block Diagram

• Nova Series DSP TL Timer Mid 2022 Block Diagram v8.4

  Please see attached. TL TIMER v8.4 FLAP v4.1 NOTE: Page 1: Nova Series Main Power Control (All Novas) Page 2: Nova 24 Without Opto Control Signals to Ruida Page 3: Nova 24 with Opto Control Signals to Ruida Page 4: Nova 35 Control Signals to Ruida ...

• Nova Series Y Axis Motion Failure

  Preface: This article will cover reasons why your Y axis will not move front to back. There can be several different causes from mechanical to electrical, including a failed sensor, failed driver, improper adjustment, belt tension etc. The only way ...

• Nova Series X Axis Motion Failure

  Preface: This article will cover reasons why your X axis will not move left or right. There can be several different causes from mechanical to electrical, including a failed sensor, failed driver, improper adjustment, belt tension etc. The only way ...