Chuck Rotary Setup and Usage in Lightburn (Nova/Odin)

Chuck Rotary Setup and Usage in Lightburn

(Nova/Odin)

The following article, supported videos and images will guide you to success with your Thunder Chuck Rotary. 

NOTE* There are a few style Chuck rotary available through Thunder Laser, Please check HERE to verify yours! If different your steps may vary.

Chuck Rotary Settings in Lightburn

In Lightburns top menu options click Laser Tools. The drop down menu will show Rotary Setup. Click this option to expand the Rotary Setup window. Follow the following steps to set up your chuck rotary.

1. Select Chuck Rotary Type
   
2. Enable Rotary
   
3. Steps per rotation should be 12,000 spr
   
4. A axis should be selected
   
5. The Object Diameter and Circumference represent your objects size in two different formats. You can enter one or the other.
   
6. Make sure that the "Read from the controller is successful" to ensure you're connected and communicating with the laser.
   

Chuck Rotary Placement and Alignment 

1. Lower your Z-Table so you can safely use the rotary without obstructions
   
2. Plug in your Chuck Rotary (motor on right)
   
3. Use your red dot laser over the track to align your Chuck Rotary moving it left to right. 
   
4. Place your object on the Chuck and use the key to secure and level your object.
   
5. Using the Manual Focus methods to bring your laser into focus with the object.
   
6. Following the video below test your graphic and your object measurements. 
   

• Related Articles

• Nova Series Users Manual

  For Thunder Laser USA support please email support@thunderlaserusa.com

• How The Chuck Rotary Works

  Preface: This article covers how a Chuck Rotary works with a Thunder Laser Quick Start Videos: Complete Guide: The Chuck rotary is pretty basic to operate. You need to know the Steps per rotation of the chuck and then your objects ...

• Chuck Rotary Setup and Usage in Lightburn (AURORA)

  Preface: This article will guide you to success with your Thunder Chuck Rotary. NOTE* There are a few style Chuck rotary available through Thunder Laser, Please check HERE to verify yours! If different your steps may vary. Chuck Rotary Setup in ...

• Roller Rotary Setup and Usage in Lightburn (AURORA)

  Roller Rotary Setup in Lightburn In Lightburn's top menu options click Laser Tools. The drop down menu will show Rotary Setup. Click this option to expand the Rotary Setup window. Follow the steps to set up your Roller rotary. Select Roller Rotary ...

• LightBurn Trial Mock Nova ODIN and Bolt Setup

  Preface: This article will walk you through a mock device setup so you can emulate a Thunder Laser in your LightBurn trial. There are two methods to do it, the Manual method where you create the profile per the instructions in the video and the ...