ThunderCAM Preset Lens Correction in LightBurn

ThunderCAM Preset Lens Correction in LightBurn


THE CAM FIELD OF VIEW HAS CHANGED. USE THE 85 or 120 FOR CURRENT LB CAMS:

85 and 120 FOV LB Cam Lens Correction Values

    • Related Articles

    • Manual Aurora Lens Calibration In LightBurn

      Manual Calibration Method: 9 Point Correction Wizard Tutorial: Additional References: Lightburn documentation

    • Aurora Installing Lightburn (non-Pro)

      Preface: This article covers installing Lightburn for your Thunder Laser Aurora Galvo laser Lightburn Software for Galvo is a powerful design and communication tool for your Thunder Galvo Laser. Following this guide will help you install Lightburn, ...

    • Legacy Thundercam Installation

      If you recently purchased a new ThunderCam kit, you should follow the instructions here instead: ThunderCAM Installation Manual Its a good idea to tape it up first and view it before you stick it down permanently. The Cable connector on the camera ...

    • ThunderCAM Installation Manual

      Preface: This article covers the installation and setup of a ThunderCam on your Thunder Laser Machine and Computer Legacy information: Previous Generation of kits Quick Start Videos: Installation Overview Calibration and Alignment Complete Guide: Its ...

    • LightBurn Material Test File

      Preface: The article covers some pre-made material test cards and the built in Lightburn Material Test Generator for CO2 lasers like the Thunder Laser Bolt, ODIN and Nova machines Quick Start Videos: New Style Test Cards Lightburn Material Test Video ...
    If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you!