Preface: This article covers the installation and setup of a ThunderCam on your Thunder Laser Machine and Computer Legacy information: Previous Generation of kits Quick Start Videos: Installation Overview Calibration and Alignment Complete Guide: Its ...
Preface: This article covers how to perform a Touchscreen calibration on your Bolt GT5 Touchscreen Quickstart Video: Video shows how to perform the calibration and the recovery method if it is messed up\non responsive Complete Guide: Basic ...
If you recently purchased a new ThunderCam kit, you should follow the instructions here instead: ThunderCAM Installation Manual Its a good idea to tape it up first and view it before you stick it down permanently. The Cable connector on the camera ...
Preface: This article covers information about setting up your Thunder Bolt Lid camera. This video will guide you through setup and calibrations in Lightburn Camera Model and Specs: Model KS5A2361: Results from WebCamTests.com Windows Device Manager: ...
Preface: This article covers the basics of aligning the laser beam on your Odin RF Laser Tools Required: Flat Head screwdriver Allen Wrenches - 1 Roll of Masking Tape 1 safety goggles SAFETY INFO: C02 Laser Radiation, PPE, & Fire Suppression Warning ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.