Thunder Laser USA Client Support

This is a diagnostic procedure to collect data on the output of the LPSU. It is not necessary to perform this unless instructed to do so by Thunder Laser US...

You need to have lightburn in mm mode when entering these values because they are metric. Then you can toggle units as you wish. also, 1m/s on the card is 1...

This is how to easily configure your steps per rotation in your machine settings from within Lightburn. Make sure you back up the settings before you...

This video will cover testing the X and Y endstops using the diagnoses menu on the controller we totally forgot to trim the first part of the video... s...

Why would my head crash? Well, there are many possible scenarios. We will go through a few here: Design and/or Operational Errors If certain conditions...

UPDATE: According to SPT, the fanning of the arc is not necessarily going to effect the output.  This is how the banding presented itself This is ...

There are actually 3 parts to this. Aligning the beam from the tube to the head, aligning the beam so its perfectly vertical and central, and finally the r...