There are actually 3 parts to this. Aligning the beam from the tube to the head, aligning the beam so its perfectly vertical and central, and finally the red dot pointer alignment. They need to be completed in that order.


OEM ADJUSTMENT DOCUMENTATION:


Aligning The Beam

The actual laser beam emitted from the tube is invisible so we have a procedure to test the alignment.




Verticality  Of The Beam

This is covered in the last part of the above video



Red Dot Pointer

1.Move the laser head on the middle of the working table.


2.Place a square of masking tape over the left side of the third mirror carriage, and mark a dot on the center, like below.




3.Use the three adjustment screws on the Red Dot Pointer Mount to move red dot to the mark dot on the tape, like below.