Resetting The DSP To Default Parameters : Thunder Laser USA Client Support

Resetting The DSP To Default Parameters Print

Modified on: Tue, Nov 9, 2021 at 4:12 PM

This procedure will reset the controller to DEFAULT parameters which are defined by Thunder Laser for your machine.

Do NOT do a factory parameters reset, only a DEFAULT parameters reset.

DO NOT PERFORM THIS PROCEDURE IF YOUR DSP CONTROLLER HAS BEEN REPLACED. CONTACT SUPPORT@THUNDERLASERUSA.COM FOR ASSISTANCE.

HF8888

NOTE: this will reset the IP address to default (192.168.001.100).

Did you find it helpful? Yes No