Update the firmware of the WIFI Card
Preface: This article covers the steps to reflash the WIFI card.
You will need:
Windows Computer with 5GB of free space, familiarity with Device Manager
Winrar
2.5mm Allen wrench
Small Flathead
USB 3.0 Printer Cable
After you are done with the reflash, change your USB and LAN IP to a different address and then set them back to what they were so that the IP gets written to the new WIFI firmware.
Walkthrough Video:
Related Articles
How to Flash a Thunder Laser Ruida DSP Controller Firmware using RdWorks for Windows
Preface: This article covers how to flash the Ruida DSP firmware using RDworksV8 over a USB Connection. You will need to install and establish the connection prior to doing a firmware flash, that is not covered in this article. Quick Start Video: ...How to Flash Screen (HMI) and Controller (DSP) Firmware on a Thunder Bolt Laser using the Screen and USB
Preface: This article covers flashing the firmware on your Bolt, for either the Screen or the Controller. Be sure to perform this only under the guidance of Thunder Laser USA. Make sure you have stable power and have time to be at the machine. ...Legacy Lightburn Material Test File
Preface: The article covers some pre-made material test cards and the built in Lightburn Material Test Generator for CO2 lasers like the Thunder Laser Bolt, ODIN and Nova machines Quick Start Videos: Legacy Material Test Cards Lightburn Material Test ...LightBurn Material Test File
Preface: The article covers some pre-made material test cards and the built in Lightburn Material Test Generator for CO2 lasers like the Thunder Laser Bolt, ODIN and Nova machines Quick Start Videos: Thunder Material Test Lightburn Material Test ...How to Flash DSP and Screen Firmware with LaserMaker
Preface: This article contains a video showing how to flash firmware by using LaserMaker. It is Mac and Windows compatible. You can connect by USB or Ethernet. This video does not cover how to connect.
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.