Understanding 20A Plug - 15A Receptacle Incompatibility
The full resolution PDF is attached at the end of the article


Related Articles
Plug Adapters for External Exhaust Fans and Stock Compressor
The stock wiring in the Thunder Laser Machine is rated for 10amps. Do not exceed more than 10amps (1200watts) of load per plug (exhaust fan and compressor output each. Total load should not exceed 10 amps. Plug identification: General location on the ...
Plug Strips & Surge Protectors
This is a guide to the quality and performance differences of a generic surge protector strip versus a proper line protection device. Most off the shelf surge protectors are not suitable for use with our machines, even the expensive multimedia ones. ...
Understanding Kerf and Kerf Offset
Kerf Description Kerf is defined as the width of material that is removed by a cutting process. It was originally used to describe how much wood was removed by a saw, because the teeth on a saw are bent to the side, so that they remove more material ...
CHEAT SHEET - Important Preparation & First Steps
Welcome and Introduction: So you just bought a new Thunder Laser? Now you are thinking "What's next?", that is what this guide is for. Be sure to use the Table of Contents to the right to follow the flow and to pick up back where you left off. This ...
Chiller Power Cord Intermittent Connection
We have had reports of the chiller having power issues due to the power connection on the rear of the chiller. The plug is not seating properly and can result in intermittent, or complete, loss of chiller power. Before you assume this connection is ...