This Information and media is used with the express permission of the owner of this machine.
Bound to happen sooner or later. Had my first “fire”. Luckily the machine detected the heat from the flame and turned off. I was in the same room and keeping an eye on it while working on other projects but I guess I looked away for too long.
***This article is a work in progress as we coordinate translations and clarity of the message, please be patient*** Below is a list of warning messages that may appear on the screen of your Thunder Bolt Machine 1、 Warning while trying to Frame or ...
DANGER: DO NOT CHANGE OUT THE OUTLET. The proper corrective action is to adapt the plug that came with your laser (the incorrect one) to fit your prescribed 110VAC 20A dedicated circuit for your laser, not the other way around. We have discovered ...
USE OF PROPER SAFETY EYEWEAR AND PPE IS PRESCRIBED WHEN DEFEATING THE SAFETY SYSTEMS TO PULSE, TEST, ETC... PLEASE SEE HERE: SAFETY INFO: C02 Laser Radiation, PPE, & Fire Suppression Preface: This article covers how to bypass the safety interlocks, ...
Preface: This article covers the steps required to set up the Air Assist protection feature on your laser machine Things you will need: -Computer than Can Run RD Works -Ability to configure RDworks to communicate with your laser Steps to Enable Air ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.