RF Tube and Fan Board Testing
RF Tube and FanBoard Testing
Note: You will need a MultiMeter, Small piece of thin wire(4-6") stripped at both ends.
To run a dummy file and meter the controller signal wire you will need to bypass the door interlock sensors.
To run a dummy file and meter the controller signal wire you will need to bypass the door interlock sensors.
Related Articles
Thunder Laser RF Tube and Fan Control Board Ports and LED Indicators for Troubleshooting
Preface: This article is high level information about the Fan Board ports and indicators and troubleshooting based of the visual observations. It is very technical Fan Board Layout: Fan Board Designations Fan Board Wiring Connections Port ...How to Clean RF Tube Air Filters on a Thunder Laser Bolt and Odin Series machines
Preface: This article covers how to clean your air filters for your RF Tube on your Thunder Laser Bolt and Odin Machine While performing this work, the machine should be powered off. Do not run your machine without the filters installed. Quickstart ...Sample Testing Gravoply Ultra 2 Color Board With Nova & Odin
Nova 35-80w Testing: Cutting air inlet pressure at 27psi. Stock 2” head with 6mm focus. Cuts and Engraves were performed at stock focus. *Note that for speed comparisons, a Odin 32 60watt will be able to cut faster than the 30w Odin 22 but it will ...How to replace the 30W RF Laser Tube on your Thunder Laser Bolt Machine
Preface: This article covers the steps to replace your 30w RF Laser Tube source on your Thunder Laser Bolt machine. This article does not cover alignment Quick Start Video: Complete Guide: The work performed should be done with the power off and the ...How to make a cable and test Pulse an RF Laser Tube for ODIN and BOLT
Preface: This article covers how to make a Test cable to be able to Test Pulse an RF tube in and Odin or Bolt Laser. Quick Start Video: How to make and used the test cable Complete Guide: How to Make the Test Pulse Cable Tools you will need: Wire ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.