Resetting The DSP To Default Parameters

Resetting The DSP To Default Parameters


Warning
Prior to resetting your defaults, backup your machine settings to your computer. Name the file with today's date and a descriptor that will help you remember.


This procedure will reset the controller to DEFAULT parameters which are defined by Thunder Laser for your machine. 



DO NOT PERFORM THIS PROCEDURE IF YOUR DSP CONTROLLER HAS BEEN REPLACED. CONTACT SUPPORT@THUNDERLASERUSA.COM FOR ASSISTANCE.


Password: HF8888





Info
NOTE: this will reset the IP address to default (192.168.001.100). If you had modified your focal values for the Bolt and Nova Plus auto focus, you should do a ramp test to dial them back in.



    • Related Articles

    • Replacing the DSP Controller

      Preface: This guide will walk you through the physical replacement of the controller. Be sure to read it completely and understand that the machine will not react like normal until the controller is configured correctly. If you attempt to use ...

    • How to Swap a GCode (Core) License to DSP (Pro) for Lightburn

      Preface: This article covers how to check if you have a DSP License installed and how to swap from a GCode/Core License to a DSP/Pro License Note that there are changes coming to the Lightburn License Structure that will go into effect Oct 1, 2024 ...

    • Updating The Firmware - DO NOT DO THIS UNLESS INSTRUCTED

      DO NOT DO THIS on a Thunder Laser USA Machine UNLESS INSTRUCTED to do so by Thunder Laser USA support. If you suspect a controller error or issue, try this first: Resetting The DSP To Default Parameters, then contact support@thunderlaserusa.com. ...

    • Laser User Origin Not Setting Correctly

      Preface: When using the Start From in Lightburn set to "User Origin", you should be able to set an Origin on the machine as your statrting position and test with a Frame operation. To set the Origin on the machine, you jog the laser head to where you ...

    • Nova Series DSP TL Timer Manual v3

      Nova Series DSP TL Timer Manual v3
    If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.

      Information contained in this Knowledgebase, on this page, in this or any other  Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.