Replacing Ruida HMI Keypad Membrane

Replacing Ruida HMI Keypad Membrane

Here is how to replace the hmi keypad membrane:


    • Related Articles

    • Replacing the DSP Controller

      If you are able to back up the old machine settings, do so. In Lightburn goto edit>machine settings. Read and Save to your computer. After replacing the DSP, go back and Load the new settings and then Write them to the DSP controller. If you are ...
    • Hard Limit Prot Error Message on Ruida HMI

      Preface: This article covers the troubleshooting steps related to the error message "Hard Limit Prot" on the ruida controller screen The message on the screen: What causes this error message: The four end stop switches for X-, Y-, and Z+/- can cause ...
    • Connecting To Controller Message on Ruida HMI

      You will need to know How To Use A Multimeterto facilitate this diagnostic procedure. You will be measuring live 110vac and other voltages so care must be taken to follow all safety guidelines and best practices. LCD panel  1. Remove the connector ...
    • How to Flash Screen (HMI) and Controller (DSP) Firmware on a Thunder Bolt Laser using the Screen and USB

      Preface: This article covers flashing the firmware on you Bolt, for either the Screen or the Controller. Be sure to perform this only under the guidance of Thunder Laser USA. Make sure you have stable power and have time to be at the machine. Failure ...
    • Troubleshooting Ruida Communication Issues

      Preface: This article covers how to troubleshoot when you have communication issues that are hardware related (Software has been properly configured but still will not communicate. Cables and adapters can present communication issues in their ...