Powder Coated Tumbler Workflow
This is a basic tumbler workflow using a Roller Rotary:
And here is the result:
The state seal was a low-resolution raster so it does not look perfect. A different vector seal was added to the final design.
Reference Video:
Related Articles
Aurora Pro EzCad3 Roller Rotary Setup and Workflow for Tumbler Marking
Preface: This article covers a sample setup and workflow for a Tumbler on EzCad3 using a Roller Rotary on an Aurora Pro 20W Mopa Fiber Laser. This article assume you know the marking parameters(hatching, power, freq) etc for the tumbler you have. You ...Circle Projection on Tumbler
This article provides an excel spreadsheet to be used to calculate the skew needed to adjust a circle onto a Rotary Surface. Prior to using this sheet, make sure you steps\roller diameter are correct for the cup you are lasering onto. Rotary Roller ...What size tumbler will fit on my Rotary with a Nova or Odin Laser Machine
Preface: This article covers max clearance height for a Rotary Object. Measurements are theoretical so if you are near the limit it would be good to double check with a mock setup prior to selling a large order. The measurements assume the stock 2" ...Leather Patch Sample Full Workflow
Odin Series Getting Started
This document is cloned from the nova series guide and is actively being updated to be completely Odin specific. Much of the content is the same across the Nova and Odin series. Welcome and Introduction: So you just bought a new Thunder Laser? Now ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you!