Nova Series Screws Securing Some Doors
This info, and more, is detailed in the Nova Series User's Manual. The information below are except from the full documentation.
10. Front up door
Open this door to use pass-through door. This door is locked by using inside screws and outside locks.
22. Right-up side door
Maintenance for the Emergency stop button if required. This door is locked by using inside screws and outside locks.
Related Articles
Nova Series Users Manual
For Thunder Laser USA support please email support@thunderlaserusa.comHow to clean and lubricate the Rails and Z Bed Screws on your Thunder Laser Nova Series machine
Preface: This guide is for Nova Series Lasers with Roller Bearing Type rails, not linear guides Lubrication for Rails and Screws The mechanical rails and rods (Z-screws) should be cleaned of debris (bearing races too) and then re-apply lubrication. ...Nova Series LPSU Replacement
Preface: This article will cover Laser Power Supply replacement on Thunder Laser Nova series machines. Before we begin: The LPSU outputs somewhere around 30,000 VDC and can store a charge so always heed the big red wires and connectors. They are ...Nova Series Getting Started
Introduction: So you just bought a new Thunder Laser? This guide will help get you up and running. We will cover topics that you should complete Before the machine arrives and After the machine arrives. Safety First: For safety information, please ...Nova Series Technical Specifications
Here are the Nova Series Specs. They can also be found in the Nova Series Users Manual.
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you!