MISSING DLL File when trying to install or Run EzCad2 EzCad3 EzCad

• Related Articles

• Aurora Driver Error for Windows Digital Signature Verification 52 for USBLMCV2

  Preface: This article covers a few steps that may mitigate and Error 52 when installing the Driver for your Aurora Machine. Not everyone's windows OS will have this issue, it is specific to your window OS settings/environment. If you get this message ...

• Machine Settings vs Project Settings when creating a Run File (RD)

  This article covers some of the settings for the Machine, Project File and Run file to describe how they interact with each other. Definitions Machine Settings Settings that live on the machine, usually edited through software like Lightburn via ...

• LightBurn Material Test File

  Preface: The article covers some pre-made material test cards and the built in Lightburn Material Test Generator for CO2 lasers like the Thunder Laser Bolt, ODIN and Nova machines Quick Start Videos: Thunder Material Test Lightburn Material Test ...

• EzCad Red light Pointer Marking Tips for lining up a Jig for Aurora Fiber

  This article covers some tips for using the Red Light Pointer for your Aurora Fiber Laser while using EzCad Things to check before using the Red Light Pointer: Alignment Before you start: Have your jig installed and secured to the bed in a repeatable ...

• How to run EzCad3 without being connected to the Thunder Aurora Laser machine

  Preface: This article covers how to run EzCad3 without being connected to the machine. This article was purposely made short and brief, as the user is expected to be versed in EzCad3 to be able to complete it. The settings changes being shown, if not ...