Installing The LightBurn CorelDRAW Macro

Installing the LightBurn macro for CorelDraw.

The documentation on performing this step can be found in the HELP tab inside LightBurn and attached at the end of this article.

The lightburn color palette for Corel is attached at the end of this article.

Please see attached document(s):

• Related Articles

• Installing The RDWorks CorelDRAW Macro

  1. First run CorelDraw and set the parameter following below instructions: 2. After that, close CorelDraw. Double click to open RDWorks installation program. Choose the type of CorelDraw_Laser (be sure the RDWorks main program has been already ...

• Aurora Installing Lightburn (non-Pro)

  Preface: This article covers installing Lightburn for your Thunder Laser Aurora Galvo laser Lightburn Software for Galvo is a powerful design and communication tool for your Thunder Galvo Laser. Following this guide will help you install Lightburn, ...

• LightBurn Trial Mock Nova ODIN and Bolt Setup

  Preface: This article will walk you through a mock device setup so you can emulate a Thunder Laser in your LightBurn trial. There are two methods to do it, the Manual method where you create the profile per the instructions in the video and the ...

• LightBurn Material Test File

  Preface: The article covers some pre-made material test cards and the built in Lightburn Material Test Generator for CO2 lasers like the Thunder Laser Bolt, ODIN and Nova machines Quick Start Videos: New Style Test Cards Lightburn Material Test Video ...

• The Lightburn License - Everything you need to know about it

  Note that there are changes coming to the Lightburn License Structure that will go into effect Oct 1, 2024 which will make some of the information in this article moot. Please read about it here. Lightburn License Overview: New Thunder Laser NOVA and ...