Preface: This article covers what worn belts may look like on your Nova series machine. Odometer Reading: Using Lightburn's "Get Controller information" we can take a peak at the odometer of the machine. The Nova 51 has over 5000 hours of movement ...
Preface: The information below will cover testing the X and Y endstops to troubleshoot X or Y axis motion issues on your Thunder Laser Nova Series machine. This article includes where to source replacement endstops and additional resources are linked ...
The small X axis belt can sometimes become 'noisy' enough to warrant replacing. This is often mistaken for bearing noise. This noise will sounds like squeaking, growling, like a bearing. But the bearings are likely okay and no lubrication is required ...
Preface: This article will cover reasons why your X axis will not move left or right. There can be several different causes from mechanical to electrical, including a failed sensor, failed driver, improper adjustment, belt tension etc. The only way ...
Preface: This article covers Odin Series Belts for the X, Y and Z axes. How to read a Belt Part Number: (Note that Length may be omitted when buying bulk or when searching for bulk length belt) Odin 22 Odin 32 Odin 22 Location Length/Part Number Qty ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.