Preface: This article covers how to change the fan board signal cable to the TL Timer on a Bolt Series Laser. Note that the process is shown on the Bolt but will be similar for the PLUS and PRO models.
***This article is a work in progress as we coordinate translations and clarity of the message, please be patient*** Below is a list of warning messages that may appear on the screen of your Thunder Bolt Machine 1、 Warning while trying to Frame or ...
Please see the manual for the Thunder Bolt and Bolt Plus below. Note that the manual is Windows and RDworks centric due to being the GLOBAL manual. Thunder Laser USA has compiled information on Lightburn, Windows and MacOS in this knowledgebase that ...
Preface: This article covers How To align your laser beam in a three mirror gantry based Bolt laser. Quick Reference Video: Complete Guide To Bolt Series Laser Alignment We recommend you sit down at a computer to read this information. It is a lot to ...
Preface: This article covers flashing the firmware on your Bolt, for either the Screen or the Controller. Be sure to perform this only under the guidance of Thunder Laser USA. Make sure you have stable power and have time to be at the machine. ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.