How to clean your Honeycomb Bed
Preface: This article covers a few methods to cleaning your honeycomb bed
Pressure Washers: Do not use a narrow nozzle or get to close to the honeycomb with a pressure washer. Use the wide spray angle to avoid damaging the honeycomb and keep the pressure washer far enough away.
Quickstart Videos:
Be sure to wear proper PPE like Gloves and Safety Goggles while cleaning your honeycomb. Follow the guidelines on the cleaner(s) you plan to use.
Method 1:
Degreaser and light pressure wash
Method 2:
Oven Cleaner and hose pipe. This is for Nova all-steel beds with no coatings. Oven cleaner should not be used on beds with colored or coated rulers or other components.
Commonly Used Degreasers and Cleaners:
Related Articles
Bolt Series Honeycomb bed size vs the working space of the laser visualization
Preface: This article covers the honeycomb bed size vs the working space of the laser. The working space is smaller than the honeycomb. Smaller machines will have a proportionally larger honeycomb since the amount of space required for the machine ...How to Clean and Lubricate the Z Honeycomb Bed Screws on a Thunder Laser Bolt Series machine
Preface: This article covers how to clean and lubricate the Z Screws on the Bolt series laser machines. The article was written based on the desktop bolt version of the machine. Quickstart Video: Complete Guide: Tools and Supplies Needed: Tool and ...Removing the Honeycomb Bed
The honeycomb bed can be easily removed for access to the blade system and for preventative maintenance. It's a good idea to familiarize yourself with the bed systems and inspect them prior to first use to ensure that these components are properly ...How to clean and lubricate the Rails and Z Bed Screws on your Thunder Laser Nova Series machine
Preface: This guide is for Nova Series Lasers with Roller Bearing Type rails, not linear guides Lubrication for Rails and Screws The mechanical rails and rods (Z-screws) should be cleaned of debris (bearing races too) and then re-apply lubrication. ...Z Axis Honeycomb Bed will not Raise or GO UP or only Goes Down until it reached the bottom
This article covers the Troubleshooting Steps for the Z Axis Honeycomb not raising up and how to bypass for testing Preface: If any of the sensors for the Auto Focus or Z Bed are bypassed, it is on the operator to make sure the machine does not crash ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.