How to adjust the tightness of the Y Axis belt
Related Articles
Example of Belt wear on a Thunder Laser Nova Series Machine
Preface: This article covers what worn belts may look like on your Nova series machine. Odometer Reading: Using Lightburn's "Get Controller information" we can take a peak at the odometer of the machine. The Nova 51 has over 5000 hours of movement ...Odin Series Belts
Preface: This article covers Odin Series Belts for the X, Y and Z axes. How to read a Belt Part Number: (Note that Length may be omitted when buying bulk or when searching for bulk length belt) Odin 22 Odin 32 Odin 22 Location Length/Part Number Qty ...Bolt Series Belts
Preface: This article covers Bolt Series Belts for the X, Y, and Z axes. How to read a Belt Part Number: (Note that Length may be omitted when buying bulk or when searching for bulk length belt) Bolt Bolt Plus Bolt Plus 24 Bolt Pro 36 Bolt Location ...Y Axis Motion Noise
When you move laser head front and back, two couplings make a lot of noise. Both sides of transmission shaft are not aligned. How to fix it? 1.Turn off the whole machine power. 2.Take out the belt by taking down the motor. Loosen three screws A ...Nova Series Y Axis Motion Failure
Preface: This article will cover reasons why your Y axis will not move front to back. There can be several different causes from mechanical to electrical, including a failed sensor, failed driver, improper adjustment, belt tension etc. The only way ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.