DSP Ad-Hoc Ethernet IP Address Configurator

• Related Articles

• Why your IP address matters and describing it in terms that are easier to understand

  Preface: This article covers a way to describe computer networking in a manner that is more relatable as it pertains to a basic setup to connect your computer to your laser Note that this article is to break things down in a very narrow scope of how ...

• Replacing the DSP Controller

  Preface: This guide will walk you through the physical replacement of the controller. Be sure to read it completely and understand that the machine will not react like normal until the controller is configured correctly. If you attempt to use ...

• How to Swap a GCode License to DSP for Lightburn

  Preface: This article covers how to check if you have a DSP License installed and how to swap from a GCode License to a DSP License Note that there are changes coming to the Lightburn License Structure that will go into effect Oct 1, 2024 which will ...

• Resetting The DSP To Default Parameters

  This procedure will reset the controller to DEFAULT parameters which are defined by Thunder Laser for your machine. Do NOT do a factory parameters reset, only a DEFAULT parameters reset. DO NOT PERFORM THIS PROCEDURE IF YOUR DSP CONTROLLER HAS BEEN ...

• MAC Connecting A Thunder Laser To LightBurn Via Ethernet

  Preface: This article describes how to set up a direct connection to the machine which omits routers, hubs and switches that can add complexity and may not work even if you are able to ping the machine. If you are connecting your laser through a ...