Critical Spare Part Recommendations for NOVA series machines

This article discusses spare parts needs for your Thunder Laser machine, verify all part numbers for your existing part.

If your laser is your business and down time is not acceptable while you wait on part deliveries, then the following are recommended:

For spare parts, be sure to check out the Thunder Laser USA Ecom Website

Part	Link to Buy	Notes
Nova 24 Beam Combiner	20 mm Beam Combiner	1 Per Machine, in back near tube exit
Nova 35,51, 63 Beam Combiner	25 mm Beam Combiner	1 Per Machine, in back near tube exit
Nova Series Mirrors	25 mm Mirrors	3 Per machine
Nova Series Stock 2" Lens	2" Focal, 20mm Diameter Lens	Other Lens are available like 4" and HR Top and Bottom
Laser Power Supply	Power Supplies	Pick the LPSU Wattage based off your specific machine
X and Y Motor	Motor
X and Y Motor Drivers	Driver 1    Driver 2	Pick the motor driver that matches your existing
X and Y Endstop Switch	X and Y Endstop	2 Locations per machine
Z Lower Limit Switch	Z Limit Switch	1 Per Machine
Roller Bearings	Roller Bearing and Bolt	16 Per Machine
Laser Tube	Laser Tubes	Pick the appropriate Tube based off your machine. Only recommend if tube is near End of Life

• Related Articles

• Critical Spare Part Recommendations for Odin Series Machines

  This article discusses spare parts needs for your Thunder Laser machine, verify all part numbers for your existing part. Links may change, expire outside of our control. If your laser is your business and down time is not acceptable while you wait on ...

• Nova Series Users Manual

  For Thunder Laser USA support please email support@thunderlaserusa.com

• Thunder Laser Bolt Series Critical Spare Part Recommendations

  This article discusses spare parts needs for your Thunder Laser machine, you must verify all part numbers for your existing part. Links may change, expire outside of our control. If your laser is your business and down time is not acceptable while ...

• Nova Series Getting Started

  Introduction: So you just bought a new Thunder Laser? This guide will help get you up and running. We will cover topics that you should complete Before the machine arrives and After the machine arrives. Safety First: For safety information, please ...

• Getting Nova Series Machines Through A Standard 30" Doorway

  User Created Video: Thunder Video: The Users Guide section will walk you through 6 steps for learning how to disassemble your Nova Note: There’s glass laser tube inside the laser machine, be careful and do not collide with anything when moving. ...