This article provides a file and instructions on how to check your offsets using a built in function in lightburn. Instructions in file: Highlight the object group and then goto Edit>Convert to Cut (Debug) Correct looking result: Zoomed in on ...
Preface: This article covers how to tell if your machine was plugged into 220v (or experienced a power surge) and which components typically fail Signs and Symptoms: Two most obvious symptoms are that the machine will power up (lights on, controller ...
Be sure to remove main power and de-energize the equipment before performing any maintenance operations take pictures beforehand for your refence then reassembling. Remove the 6 hex screws Remove and retain the 6 hex screws that secure the top panel: ...
Preface: This article covers a few tests and checks for when your laser is not firing. Some of the tests are visual inspections while others will require you to change the machine configuration and run diagnostics Quick Start Videos: Use these videos ...
Preface: This article contains information on how to the check the function of the Thunder Bolt Endstops and how to adjust them Quick Start Video: Complete Guide: This guide aims to cover how to check a Bolt X or Y Endstop for function, how to adjust ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you! You can also use the form here.
Information contained in this Knowledgebase, on this page, in this or any other Article etc. is the property of Thunder Laser USA and shall not be copied, re-used, sold etc. Do not copy, distribute, or reproduce without express written permission from Thunder Laser USA.