Calibrating The Z Table

Calibrating The Z Table

How to calibrate the working table to level.

There are three cases.

1. Two sides of the working table are not of the same height

Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of the working table height of this side and calibrate the level in this way.


Shown as below:

 


2. One of the four corners that is of different height from the other three corners


As shown above, by adjusting these screws you can fine adjusting the support frame of the knife table so as to calibrate height of one corner. 


If neither of above two methods can solve the problem, please adjust according to below steps.

But it’s much more difficult. Please handle it carefully.

 3. Adjust the lead screws 

 

⑴ Loosen the screws of the fixed module. The belt will be loose accordingly.

⑵ Rotate the lead screws to calibrate the table height of this corner. (PS: rotate it clockwise, table in this corner will go up; turn it anticlockwise, table will go down)

⑶ Working table of this corner will go up or down when you rotate the lead screw in different directions.


 

End



Also, please see this



    • Related Articles

    • How to clean your Honeycomb Bed

      Preface: This article covers a few methods to cleaning your honeycomb bed Pressure Washers: Do not use a narrow nozzle or get to close to the honeycomb with a pressure washer. Use the wide spray angle to avoid damaging the honeycomb and keep the ...

    • Calibrate the Z Axis Honeycomb Travel

      The Z axis honeycomb travel is a little different to calibrate than the X and Y but it is the same principle and will still use the Lightburn Wizard found here: Calibrating Axes In LightBurn For this activity you will need: -A sturdy measuring tape ...

    • How to Level your Honeycomb bed to your Laser Head on your Thunder Bolt Machine

      Preface: This article covers the basics of leveling your Honeycomb bed on your Thunder Bolt Laser Quick Start Video: Complete Guide: Tools you will need: 2.5mm Allen Wrench (silver) 4mm Allen Wrench (red) Small Flat uniform material (MDF Disc) Bolt ...

    • Removing the Honeycomb Bed

      The honeycomb bed can be easily removed for access to the blade system and for preventative maintenance. It's a good idea to familiarize yourself with the bed systems and inspect them prior to first use to ensure that these components are properly ...

    • Bolt Series Honeycomb bed size vs the working space of the laser visualization

      Preface: This article covers the honeycomb bed size vs the working space of the laser. The working space is smaller than the honeycomb. Smaller machines will have a proportionally larger honeycomb since the amount of space required for the machine ...
    If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you!