Axis Makes Grinding or Shuttering Noise while Moving
A common issue with the Ruida controller is it's inability to receive a file and move at the same time. Typically this happens as the anxious laser user sends a file over to the laser, then walk over to the laser to set up the job while the file is mid transfer to the machine.
The best solution to wait a moment for the file to be sent to the machine completely. Then you can freely move your axis into position for your next project.
Preface: This article contains information on how to the check the function of the Thunder Bolt Endstops and how to adjust them Quick Start Video: Complete Guide: This guide aims to cover how to check a Bolt X or Y Endstop for function, how to adjust ...
When you move laser head front and back, two couplings make a lot of noise. Both sides of transmission shaft are not aligned. How to fix it? 1.Turn off the whole machine power. 2.Take out the belt by taking down the motor. Loosen three screws A ...
Preface: The information below will cover testing the X and Y endstops to troubleshoot X or Y axis motion issues on your Thunder Laser Nova Series machine. This article includes where to source replacement endstops and additional resources are linked ...
The Z axis honeycomb travel is a little different to calibrate than the X and Y but it is the same principle and will still use the Lightburn Wizard found here: Calibrating Axes In LightBurn For this activity you will need: -A sturdy measuring tape ...
Preface: This article covers how to manually square your gantry back for the X and Y axes. This procedure is most often done after a head crash and is useful to check your gantry prior to a re-alignment of the laser beam. Quickstart Video: ***coming ...
If you are a Thunder Laser USA client and still need Technical Support after exhausting the resources in the Knowledge Base, simply email support@thunderlaserusa.com and the Technical Support Team will promptly assist you!