AirTAC DSP digital pressure sensor

Users Manual for AirTAC DSP Digital display pressure sensor 

See PDF attached. 

• Related Articles

• Bolt, Nova Plus and Odin Air Pressure Sensors Manuals and Technical Data

  Preface: This article covers the Airtac and SMC air pressure sensors that were installed in and shipped on some Odin and Bolt series models. Confirm your part number on your machine. Manuals are attached at the bottom of this article. For the most up ...

• Replacing the DSP Controller

  Preface: This guide will walk you through the physical replacement of the controller. Be sure to read it completely and understand that the machine will not react like normal until the controller is configured correctly. If you attempt to use ...

• SMC ISE30A-01-N-L Pressure Switch Implementation Reference

  Introduction The air assist is critical for keeping flare-ups at bay, mitigating smoke, helping keep the lens cleaner and cooler (it really shouldn't get that hot if it is in proper order anyway), and, when cutting, catalyzing the ablation of ...

• How To Set up Air Assist Protection on the Odin 32 with the built in Air Pressure Sensor

  Preface: This article covers the steps required to set up the Air Assist protection feature on your laser machine Things you will need: -Computer than Can Run RD Works -Ability to configure RDworks to communicate with your laser Steps to Enable Air ...

• Air Solenoid Differences

  Preface: This article covers the different models of air solenoids used on Thunder lasers. Thunder Laser has used the three different types of solenoids as shown below. All 3 are still the same hose input sizing and 24V solenoids. You should be able ...