60 Watt Materials Libraries

60 Watt Materials Libraries

*This information is provided “AS IS” to provide a starting point. It is always a good idea to run tests on each substrate and update the library as necessary.


The Official Thunder Material Library PDF as well as the precompiled LightBurn library file are attached below.


The LightBurn file may differ from the original document.


Here is short tutorial on how to upload the clb file into LightBurn: Uploading the LightBurn Materials Library




​​​​
    • Related Articles

    • 130 Watt Materials Libraries

      *This information is provided “AS IS” to provide a starting point. It is always a good idea to run tests on each substrate and update the library as necessary. The Official Thunder Material Library PDF as well as the precompiled LightBurn library ...
    • 40 Watt Materials Libraries

      *This information is provided “AS IS” to provide a starting point. It is always a good idea to run tests on each substrate and update the library as necessary. The Official Thunder Material Library PDF as well as the precompiled LightBurn library ...
    • 80 Watt Materials Libraries

      *This information is provided “AS IS” to provide a starting point. It is always a good idea to run tests on each substrate and update the library as necessary. The Official Thunder Material Library PDF as well as the precompiled LightBurn library ...
    • 100 Watt Materials Libraries

      *This information is provided “AS IS” to provide a starting point. It is always a good idea to run tests on each substrate and update the library as necessary. The Official Thunder Material Library PDF as well as the precompiled LightBurn library ...
    • Estimating Power Output Without A Laser Power Meter

      You will need the 50mmx50mmx6mm acrylic square that comes in the toolbox: Keep the laser power at 95% and you want to determine the fastest you can cut through in one pass: A decent starting speed can be found if you aren't sure where to begin. for ...